Activity Stream

Filter

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Older Activity
6th June 2023, 05:30 PM

Pilot replied to a thread Using Cashew Gate on TPE in General Injection Molding

Hi Joe, is hard to say what is wong. Please check the weight of part vs sprue tip diameter. For example for TPE is recommended for 10 grams part...

see more

2 replies | 82 view(s)
5th June 2023, 07:29 AM

Jendalf replied to a thread Using Cashew Gate on TPE in General Injection Molding

Hi Joe, can you place here a picture of the sprue (sprue that gives OK part and case, where the part is NOK). Also pls add what shore is the...

see more

2 replies | 82 view(s)
1st June 2023, 01:34 PM

joeprocess started a thread Using Cashew Gate on TPE in General Injection Molding

Have a 4 cavity part that is being overmolded with 45 Durometer TPE. The part is cashew-gated and cannot be changed to a different gate style. Once...

see more

2 replies | 82 view(s)

No More Results

All times are GMT +1. The time now is 01:42 AM.

Powered by vBulletin® Version 4.2.3
Copyright © 2023 vBulletin Solutions, Inc. All rights reserved.