Activity Stream

Hi From my experience no Krauss, Engel but control CC 200, have few of them only every 2 year change oil and run. My company run 24/7, so you no...

I wouldn’t use disconnects due to coming off, leaking seals and soon. I would JIC or Flare fittings. If you’re worried about change over times, plumb...

Has this ever ran good? The pitting sounds like gels or unmelted pellets. The nozzle tips looks incorrect for the sprue too. I would use the...

OK J The material is pre-colored grey, thx for the feedback! Joel

OK, thanks everyone for feedback :D Joel

Hey Joel, We typically run everything from 250 and below on water here. Anything above on oil. With high temp water hoses and fittings - it's not...

hi, I am running several moulds on 120°C (248F) water. Nipples on moulds DME, Hoses Hi-temp metal braided with teflon inside, thermolators Wittmann...

hi Sr I think your ROI its not so good to decide to buy a new machine, will be a lost for you $,, do you already calculate the part cost now...

Hi Joel We use same temp, running with matsui tmp controller,, any way , we use high temperature hoses cover with metal mesh , technician should...

Hi, You have to have also special fittings and connectors. Tool have to be prepared for this as higher water temperature than boiling temp....

Hi, two things. 1) it looks like wrong mixing - the screw is not able to mix the colour into the natural homogenously. Than when injected the...

So are we saying that the beautifully made polycarbonate Cambro containers have unnecessarily large gates? Surely they were sized around 8-8.5mm for...

Hi, If I understand this, wall thickness is 2.5-3mm and gate is 6mm, so my opinion is that increasing gate size will not help. Joel

Are you pressure limited on the current machine by any chance? Suhas

Hello Joel, There are special units that run high temp water. I hear that there are units that go up to 350 deg F. Yes, you will need special hoses...

FANUC. Even if it's used, we have multiple 150 ton roboshots, some of them are 16 years old, running 24/7 and the repair cost is almost 0. I can...

We have four molds that use those pins we have run them in multiple machines and we run them all the time and never had that much of a problem. We...

Hi, Yes, Dryer recleaned, hoses recleaned, loader removed and put in hopper via clean bucket, with no difference. Can't see any ej pin flash, dme...

Was the dryer and hoses cleaned properly from the last job? I know you said you cleaned the screw and barrel, but how about the feed throat from the...